B ookmarks made with Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- 2" x 4-1/2" from Very Vanilla Cardstock
- 2" square of color and design of choice from 2021-2023 In Color 6" x 6" Designer Series Paper Assortment
- 1-1/2" x 3-1/4" from Very Vanilla Cardstock
Unlock the Delightful Tag Topper Punch. Slide one short edge of the 2" x 4-1/2" vanilla strip into the punch as far as it will go and get it centered. Punch.
Mount the lady and dog snuggled up with a book image from the In The Moment Set on Block D. Ink it up with the Tuxedo Black Memento Ink Pad. Stamp it in the center of the punched vanilla tag near the top.
Use the regular Stampin' Write Marker color of your choice to color in only the book on the stamped image.
Adhere the color and design square of your choice from the 2021-2023 In Color 6" x 6" Designer Series Paper Assortment to the bottom of the punched, stamped, and colored tag.
Mount the "relax" sentiment from the In The Moment Set on Block B. Ink it up with the color ink pad of your choice and stamp it on the horizontal 1-1/2" x 3-1/4" vanilla strip near one end.
Note: If making multiple bookmarks using different colors, be sure to clean the stamp between colors using the Stampin' Scrub and Stampin' Mist Stamp Cleaner and/or Simply Shammy.
Unlock the Label Me Fancy Punch. Holding the punch upside down so you can see the punching area, slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Use the side of the brush tip of the regular Stampin' Write Marker color of your choice to carefully outline the sentiment punch out.
Adhere the outlined sentiment punch out to the front of the tag so it is centered over the seam between the designer paper and the vanilla tag.
Cut a 6" piece of the ribbon of your choice.
If using the Black & White 1/4" Gingham Ribbon, lay the piece of ribbon on some Grid Paper to protect your work surface. Use the brush tip of the Stampin' Blends marker of your color choice to color the ribbon on both sides.
Slide one end of the ribbon through the hole in the top of the tag. Pull the ribbon through so it is even.
Cut a 10" piece of the baker's twine of your choice from the Baker's Twine Essentials Pack.
Wrap the twine around the ribbon near the top of the tag. Tie in place with a small bow. Trim the ends of the twine and the ribbon.