S pring is taking its sweet time to roll in with the weather. So we can at least bring forth Spring on paper. These two sets from both the occasion and the annual catalog and great papers are all about Spring.
Project Recipe
1. Cut Berry Burst paper 4 1/4 in x 11in score @ 5 1/2 in then cut off 2 3/4 in.
2. DSP 2 1/2 in x 4 in is layered on the front fold of card front.
3. Whisper White 2 1/2 in x 4 in is layered on Berry Burst portion that was cut off card base. and this is secured to card front horizontal across middle of card.
4. Whisper White 4 in x 5 1/4 in stamp sentiment in lower right corner with Highland Heather. Stamp one of the flower stamps in in berry burst in top left corner. Layer inside card.
5. Stamp Teapot on Highland heather teapot diet.
6. Stamp flower on DSP diecut and place on teapot. Place flower enamel embellishment in center of flower.
7. Stamp teacup on DSP diecut.
8. Layer Teacup first on center of card and then place teapot over teacup with dimentionals.
1. Whisper White 8 1/2 in x 5 1/2 in folded at 4 1/4 in.
2. Petal Pink 4 in x 5 1/4 in. Layer on card front.
3. Pear Pizazz 3 3/4in x 5 in ran thru lace embossing folder.
4. Lovely Romance DSP thru stitched rectangle. Using same rectangle, also cut out piece of Whisper White.
5. Take DSP rectangle and place some adhesive tape 1 1/2 wide across the top. Then place half arch window the top between the stitches.
6. Secure DSP rectangle to white rectangle. Then secure the cutout window to this open area, remove layer from adhesive so it is now a sticker.
7. Place thin pink ribbon across bottom of window edge and wrap to back side.
8. Secure this rectangle to front of card.
9. Stamp sentiment on white stitched rectangle, used pear pizazz. Position lower edge of rectangle with dimentionals.
10. Stamp Bird, Butterfly or Flower on their diecut. Color and position, above sentiment.
1. Start with 6 in x 6 in paper.
2. Score one side 1 1/4 in and 4 3/4 in
3. Score other side 2 1/2 in and 3 1/2 in.
4. Use strong tape or glue in all four corners.
5. In the middle you are going to fold back the center edge diagonal up ti edge paper. This will let it fold up to a purse.
6. Place Silver edge ribbons looped around each side of purse. with glue dots.
7. Place strip of DSP 1/2 in x 3 1/2 in across top edge of purse covering ribbon.
8. Using Pretty Label that has been ran thru Lace embossing folder. Apply Glue and secure on one side between ribbon loops.
9. Place provided Butterfly on front with dimensional to front of label.
10. After filling goodies in your purse use secure close with dimensional or glue dot on other purse side.