Painted Harvest Thank You Card
T his card was made for my customers to thank them for their support
Whisper White Thick Cardstock Base
Crushed Curry 5.25 x 4
Early Espresso 3-1/8 x 4-1/8
Designer Paper 3 x 4
Whisper White 4.5 x 1.25"
Early Espresso 4.5 x 1.50"
scraps of Garden Green cardstock
scraps of Lemon Lime Twist cardstock
I first cut the designer paper into 3 x 4" pieces so you get 12 pieces from a single sheet of 12 x 12 paper. I then layered one of those onto the Early Espresso piece of cardstock.
I took the whisper white strip and the early espresso strip and banner cut the ends using the Banner Triple punch. (You could also just banner cut those pieces using your paper snips)
I then stamped the sentiment in Garden Green onto the whisper white piece.
Using Garden Green ink, I stamped the leaf onto garden green cardstock and onto lemon lime cardstock. I then used the Leaf punch to punch out leaves.
I cut about 11 inches of Crushed Curry Bakers twine and wrapped it 3 times around the end of the banner sentiment piece and tied it off.
Using Multipurpose glue I put some glue on the stems of the leaves and put them under the twine on the banner.
Next I began assembling the card. I attached the Crushed Curry piece to the card base.
I then took about 2 inches of Copper trim and stretched out one end. Using glue, I added it to the Crushed Curry piece.
Next I added the designer paper layered piece so that a small amount of the copper trim showed in one corner.
Using dimensionals I attached the banner piece at an angle.
Finally I stamped a leaf in Garden Green to the inside bottom left corner.