Anne Power
http://stampspaperink.com maw2map@aol.com |
Merry Moments shaker card |
|
T ree punch and Merry Moments designer paper along with Lot's of Joy Stamp set combined with Lot's of labels framelit dies create a fun shaker card.
|
|
|
Real Red mat is 4.25 x 3.25, Patterned Paper is 3 x 4, use two sizes of the Labels framelits Silver glitter paper is 5/8 by 3. Tree is cut from Heavy weight Whisper White. Heavy Weight Bakers twine is cut to 12 inches.
DSP has been adhered to the mat along four edges. The large label was then cut centering left to right and toward the top to leave room for silver glitter paper.
Stamp White Label piece with Merry Christmas in real red. Lay Designer Series Paper panel on card front centered-don't adhere. Center Label in window opening and adhere in place.
Adhere window sheet to the back of the DSP panel and mat. Fast fuse or other strong adhesive works well for this. Once window sheet is attached frame opening with foam tape that you cut in half length wise, keeping it close to the window.
Glitter paper panel was punched with the Banner Triple Punch centering carefully. Adhere panel down and tie Bakers Twine around and in a bow.
Sprinkle a few sequins on the label-not many you don't want to make it so you can't see the greeting. Adhere down the whole window piece centering as best you can and trying not to trap any sequins in the foam tape.
Tree was stamped in old olive and punched out. Adhere with dimentionals