H oney Bee Bundle with Saleabration Golden Honey DSP and Follow your art Washi tape
Project Recipe
Daffodil Delight Card Base 8.5x5.5
Basic Black 4-1/8X5-3/8
Golden Honey DSP (Saleabration) 2x4, cut bee
Scrap Daffodil delight to cut 3 honey combs and punch the label
Whisper White Card Insert
Scrap Whisper White 7/8 inch wide for sentiment
Using scrap Daffodil Delight cut 3 honey combs, keeping a few of the centres.
Using the Label me Fancy punch, punch a Daffodil piece for the sentiment background.
Using the large bee frame die, cut the bee from the DSP using the Honey Bee dies.
On the scrap 7/8 inch wide Whisper White, stamp the sentiment using Memento and then using the Label me Fancy punch, center the strip in the punch to curve the ends. Adhere this to the Daffodil label creating the layered label.
Adhere a strip of the yellow washi from Follow Your Art just above the half inch mark on the black piece.
Adhere the 2x4 DSP to the left side of the card leaving 1/16 inch border on three sides.
Adhere three pieces of honey comb to the black piece using your choice adhesive. I used stick dot paper that Stampin' Up! used to sell. You will need to overlay them in places and trim the edges of the comb off. Glue a few centres back in for interest.
Colour the wings of the bee with light Smoky Slate Blends and the body stripes with dark Black Blends. Be very careful at the edges as the paper is quick to bleed over.
Using dimensionals place the bee and the sentiment label on the card as desired.
The small bee image was stamped on the insert and the envelope for interest.