U
se the Swirly Bird Bundle and Birthday Banners stamps and framelits to make a cheery birthday card!
My Online Store:http://www.stampinup.net/esuite/home/carolpayne/
Email: carol@carolpaynestamps.com
Call or text: 618-237-6281
NOTE: Always put the Stampin' Pierce My Stampin' Up!-Only Blog: www.carolpaynestamps.com
mat under your card stock when stamping with Photopolymer stamps to achieve a well-stamped image.
Project Recipe
Dimensions:
Dapper Denim card base: 8 1/2" x 5 1/2", scored and folded at 4 1/4"
Real Red layer: 4" x 5 1/4" -need two
Whisper White layer: 3 3/4" x 5" -need two
Dapper Denim for scallop circle:3" x 3"
Whisper White for focal image circle: 3" x 3"
Dazzling Diamonds Glimmer:2" x 4"
Dapper Denim strip: 1" x 4"
Whisper White for greeting: 1 1/4" x 4"
Dapper Denim 3/8" Ruched Ribbon for flag: about 2"
Brights Designer Paper to line envelop: 2 1/4" x 5 5/8"
Emboss white front layer with Large Polka Dot folder.
Adhere to red front layer with SNAIL.
Adhere both layers to card front with a dimensional in each corner.
Cut Dazzling Diamonds Glimmer paper with the long swirling thinlet. Roll with the Die Brush to remove from the thinlet and the little pieces.
Adhere to just below the center of card front with Fine Tip Glue.
Stamp sailboat on white using Crumb Cake for the body of the boat, Real Red for the striped sail and Dapper Denim for the smaller sail.
Cut with a Layering Circle Framelit.
Stamp the boat pieces again on a Post-it Note and cut out. leaving a thin line of post-it around the boat.
Cover the stamped boat with the post-it mask. Stamp the splatter stamp over the post it and around the boat. Stamp once with full-strength Dapper Denim, then stamp a second time without re-inking.
Remove the post-it mask.
Fold the ribbon in half and cut a "v" with scissors in the end after you trim the ends to the length you want.
Adhere folded ribbon "flag" above the boat with the Handheld Stapler.
Adhere finished circle to Dapper Denim scallop circle with SNAIL.
Adhere all to card front with dimensionals.
Adhere Dapper Denim strip to lower area of card front with SNAIL.
Stamp white strip with "Happy Birthday!" from Birthday Banners and Real Red ink.
Cut with banner framelit.
Adhere to center of Dapper Denim strip with dimensionals.
Adhere a Dapper Denim enamel shape to each end of banner.
Adhere remaining Real Red layer inside card with SNAIL.
Stamp white inside layer as desired.
Punch one end of 2 1/4” x 5 5/8”” of DSP with Gift Bag Punch Board, lining up the edge of the paper with the “Start” line on the board before punching. Flip paper end-over-end and line up the opposite side of the paper with the “Start” line before punching again. Adhere inside envelope just below the glue line using a line of SNAIL ONLY along the top edge of the liner. Fold envelope flap down to crease the liner and push it farther down into the envelope. Stamp the envelope to match your card and you are done!