Project Recipe
Make a card base from Whisper White 8 1/2 x 11 cardstock. Cut the sheet in half at 4 1/4". Score each half at 5 1/2".
Cut a piece of Blushing Bride Cardstock to 4" x 5 1/4".
Cut Whisper White Cardstock to 3 3/4" x 5".
With the bell stamp from the Blended Seasons Set and the Blushing Bride Ink Pad, stamp the bells diagonally on the 3 3/4 x 5 cardstock leaving a band of white the height of the bell between lines. Try stamping randomly, or in lines.
Using the same method, fill in the white gaps left using the bell stamp and Pool Party ink pad.
Using the small stitched framelit (approx. 3 1/4" x 2 1/4") and a Cricut or Big Shot, cut out from Whisper White.
dab a sponge onto the Pool Party Ink Pad, ink the edge of the frame.
TIP:
If I'm looking for just a slight discoloration of the edge of my paper, I hold the paper in my hand. With the sponge perpendicular to the paper I run it up and down the edge a few times. If I'm looking for a more smoky, thicker inked edge, I lay my paper on the table with a scrap of paper underneath and I use my inked sponge almost flat against the paper and I draw it back over the edge a few times.
Using leftover pieces of Blushing Bride Cardstock, cut out the bow using the Framelit Die.
Dab small amounts of Multi-Purpose glue on bow and adhere to frame near the bottom or top.
Using either Pool Party or Blushing Bride Ink Pads, stamp the bell onto Whisper White 3 times. Cut these images out with the bell framelit.
Assembly: adhere to your card base the Blushing Bride cardstock, then your bell homemade cardstock. Pop the frame and three bells with dimensionals.