Project Recipe
3" x 6" piece of Night of Navy
2 3/4" x 5 3/4" piece of Whisper White
Stamp the birds in Night of Navy
Run white card stock through Subtle embossing folder.
Glue the white to the blue
Stamp the anchor on a piece of Sahara Sand using Night of Navy and cut out using the anchor framelite.
Cut a 6" piece of bakers twine and run through the hole at the top of the anchor. Tie a half knot or a knot that you like.
I like to fray the ends of the bakers twine.
3" x 3" Night of Navy Card Stock
3" x 2" piece of Designer Series paper (DSP) and cut a banner in the bottom.
1 1/2" x 2" piece of DSP cut a banner in the bottom .
1" x 2" piece of DSP cut a banner in the bottom.
Choose different DSP to give interest.
Glue these to the 3" x 3" piece of Night of Navy leaving a boarder.
Use the rope die to cut the rope knot and the rope from whisper white.
Glue all pieces on the Night of Navy 3" x 3" piece
3" x 6" piece of Night of Navy
2 3/4" x 5 3/4" piece of Whisper White
Stamp the light house and the birds three times on the whisper white card stock using Night of Navy ink.
Run the white card stock through the Subtle embossing folder
Cut out the wheel using Night of Navy Card stock.
Glue all pieces together.
3' x 6" piece of night of navy
2 3/4" x 5 3/4" piece of whisper white
On the whisper white stamp the sail boats and the birds in Night of Navy ink.
Run the whisper white through the Subtle embossing folder.
Stamp on a piece of Sahara Sand the Word and cut out using the word die.
Sponge around the edges with Night of Navy.
Glue all pieces together.
Adhere the Words with dimensionals
Cut (2) pieces of bakers twine and make a knot in the middle.
Wrap the ends of the bakers twine to the back and glue in place with glue dots.
3" x 3" piece of Night of Navy
2 3/4" x 2 3/4" piece of DSP (Compass paper)
Glue these two pieces together.
Punch out the scripture with a 2" punch.
Punch out a 2 1/4" piece of Night of Navy.
Glue them together and adhere to the front using dimensionals.
3" x 3" Night of Navy Card Stock
2 3/4" x 2 3/4" Whisper White
Stamp in Night of Navy ink the birds
on the Whisper white card stock.
Run this piece through the Subtle Embossing folder.
Glue to the Night of Navy 3" x 3" card stock
Punch a 2" piece from Night of Navy.
Stamp the compass in Night of Navy and punch out using an 1 3/4" punch.
Cut out compass needle in Night of Navy.
Use a brad to attach the needle to the compass. I used a paper piercer to make the hole in the center.
Attach to the 2" Night of Navy card stock with Dimensionals.
Now all you have to do is arrange on a 12 x 12 piece of DSP of your choice. Make sure all margins are even as this makes for a more finished look on a sampler.