D elicate Forest Fun Fold Card. Case'd from Amy Koenders with slight modifications made.
Project Recipe
Measurements:
Garden Green Card Base -
5 1/2" x 8 1/2", score @ 4 1/4"
Shaded Spruce -
4 1/4" x 5 1/2" - use the top and bottom
part of this panel to cut the 2 greenery
dies
Basic White -
4" x 5 1/4" - inside panel
3 1/2" x 5/8" - sentiment
DSP -
5 1/4" x 4 11/16" (one notch below
4 3/4")
Score DSP 1/2" from right side
Instructions:
Take the 2 pieces of Shaded Spruce die cuts and stack one on top of the other (it doesn't matter how you layer them). Apply a thin line of liquid glue on the bottom edge of the bottom piece. Make sure the bottom and the side edges are aligned.
Cut the front of the Garden Green card base with the large die. Be careful when you are poking out the cut pieces, not all of the leaves are meant to be removed.
Open the card base, and dry fit the Shaded Spruce die cuts at the bottom of the card front. You want the right-hand side to align just in front of the score line. If you have it over this line, the card won't close properly. Remove the die-cut piece and apply a thin line of liquid glue to the inside bottom of the Garden Green card base. Attach the Shaded Spruce piece.
Trim off any overhang from the opposite side of the Shaded Spruce die-cut piece.
Fold the DSP on the score line. Apply adhesive (liquid glue or tear tape are recommended) to the 1/2" scored portion and align it to the right-hand edge of the inside card base. The DSP should be right to the edge of the card base, or it will affect the cards ability to close properly.
Stamp your sentiment and the small tree images on the 4" x 5 1/4" piece of white cardstock. Make sure the DSP piece is open (folded back to the right side of the card base) and adhere the white layer to the inside of the card. (NOTE - I initially used the large shrubbery stamp on the example, but didn't care for it afterward, so I changed it to the image of the small trees.)
Fold the DSP piece back over to the left and the card front to the right.
Place the Brass Butterflies in the opening on the front.
Stamp your sentiment of choice on the Basic White sentiment die-cut piece. Adhere the sentiment to the bottom center of the card front. You can adhere this flat or use small dimensionals to raise it a bit.
Stamp the small trees on the lower left of the envelope.
You are finished!