A nice layout to show the various patterns in a package of our Designer Series Papers.
Project Recipe
Measurements:
Moody Mauve -
8 1/2" x 5 1/2", score @ 4 1/4"
Scrap for the top of the vase
Pebbled Path layer -
5 1/4" x 4"
Misty Moonlight -
1 1/2" x 2 1/4" for vase
Basic White -
5 1/4" x 4" - insert
scrap for banner die-cut
Crumb Cake -
4" x 2 1/2" for fronds in vase - cut 2
DSP -
1 3/4" x 1 3/4" - 4 different designs
Ribbon -
6 1/4"
Score and burnish card base.
Take the 4 squares of DSP and attach them to the left side of the Pebbled Path layer. Line them up along the top and the bottom. There will be a larger space between the middle, that is where the ribbon goes.
Lay the ribbon between the top and bottom rows of squares. wrap the ends around to the back of the layer and attach with double-sided adhesive.
Attach the layer to the front of the card base.
NOTE - if you use a thicker ribbon for this card, you may want to attach the layer using dimensionals so that there's no noticeable bump where the ribbon wraps around.
Die cut the following:
Misty Moonlight - vase
Moody Mauve - vase top
Crumb Cake - fronds for the vase, cut 2
Basic White - banner
Take the Misty Moonlight vase die cut and run it through the Timeworn Type Embossing Folder.
Attach the Moody Mauve die cut to the top of the vase die cut.
Apply a small line of double-sided adhesive along the back of the vase, then attach the stems of the 2 fronds along the adhesive strip.
Apply dimensionals to the vase and attach it to the card front, on the right-hand side.
Stamp the sentiment on the Basic White banner. NOTE - It may be easier to stamp the sentiment on a scrap of Basic White and then die-cut it.
Attach the sentiment over the trim using dimensionals.
Apply sequins to the card front.
Using the Basic White 4" x 5 1/4" layer, stamp the inside sentiment using Memento Ink. Stamp leaves from the stamp set using Misty Moonlight ink and adhere the layer to the inside of the card.
You are finished!