Excellent Eggs Easter Eggs and Bunny

{ tams # 86937 }

Print Recipe

Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Boho Blue Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Bubble Bath Cardstock
- 3-7/8" x 5-1/8" of blue colorwash design from Flight & Airy 12" x 12" Designer Series Paper
- 2-3/4" x 3-1/4" of pink and blue flowers with green stems and leaves on light pink background design from Flight & Airy 12" x 12" Designer Series Paper
- 1-3/4" x 2-1/4" of purple and pink colorwash design from Flight & Airy 12" x 12" Designer Series Paper
- 1-3/4" x 2-1/4" from Bubble Bath Cardstock
- 1-1/2" square from Basic White Cardstock

Mount the "happy Easter" sentiment from the Excellent Eggs Set on Block C. Ink it up with the Boho Blue Ink Pad. Stamp it in the upper right corner of the horizontal blue colorwash Flight & Airy Designer Paper rectangle so it is about 1/2" from the top and right edges.

Adhere the stamped blue colorwash designer paper rectangle to the center of the large Bubble Bath rectangle and then to the front of the Boho Blue card.

Pick out the open egg die from the Excellent Eggs Dies that cuts out an egg that is 2-3/4" tall. Put it on top of the floral Flight & Airy Designer Paper rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.

Adhere the floral egg cut out to the front of the card so the pointy end is up and the left side of the egg is about 3/4" from the left side of the card and the bottom of the egg is about 1/2" from the bottom of the card.

Pick out the small, detailed egg die from the Excellent Eggs Dies. Put it on top of the pink and purple colorwash Flight & Airy Designer Paper on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces as needed.

Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the detailed purple and pink colorwash egg cut out to the small Bubble Bath rectangle.

Use Paper Snips Scissors to cut around the edge of the detailed egg cut out cutting off excess Bubble Bath cardstock.

Adhere the pink and purple egg cut out to the card front so the pointy end is at the top at a slight angle and the left side of the egg overlaps the right side of the large floral egg cut out a bit and the bottom is in line with the bottom of the other egg cut out.

Mount the small bunny image from the Excellent Eggs Set on Block B. Ink it up with the Pecan Pie Ink Pad. Stamp it in the center of the small white square.

Pick out the matching, open bunny die from the Excellent Eggs Dies. Put it on top of the stamped image on a platform on your Stampin' Cut & Emboss Machine so the image is centered in the die. Run through the machine.

Use Mini Stampin' Dimensionals to adhere the bunny cut out to the front of the card so it slightly overlaps the right edge of the small egg cut out and the bottom is in line with the bottoms of the egg cut outs.

Cut a 3-1/2" piece of the Boho Blue 3/8" Textured Ribbon.

Tie a half knot in the center of the ribbon. Trim the ends.

Use a Mini Glue Dot to adhere the ribbon knot to the front of the card as shown at a slight angle over the bottom left side of the large, floral egg cut out.