1
) A2 card: cut 8 & ½ x 11 cardstock in half and score the one half @ 4 & ¼
2) Cut a piece of DSP to 3 x 4 in. and curl end of each corner with fingers & adhere to front of card slightly slanted to one side.
3) Layer on next DSP paper 3 x 3 in and adhere slightly tilted the opposite of the first one.
4) Add the 2 small DSP papers that are 1x 3 in: rip the end of the 1st piece on the very edge and cut the 2nd piece into a banner by making a triangle on the end of one piece, then adhere both one on top of the other and slightly to the right of the top of the other layers.
5) Using the piece of cardstock that is 2 x 5 & ½ in you can cut into a banner by using the triple punch or you can just cut by the end into a triangle. Stamp the “Happiness is” stamp to paper before or after cutting out. Adhere to other layers.
6)Take the 6 in. ribbon and fold in half and then tie the thread ¼ of the way down from the top and tie into a bow. Adhere to card on left side of banner, but closer to the edge of the left side so there is room between this and the banner for the cups.
7) Add the 2 small cups (cut out of DSP paper using the coffee cup framelit) and adhere to card using the dimensionals and place them slightly away from each other.
8) Adhere the coffee bean cut-out to right top hand corner of the 1st layer of DSP (cut out from stamped coffee beans and framelit)
9)Use coffee bean stamp with choc. Chip ink pad for stamping some coffee beans inside the card and on flap of envelope.