Gone Fishing Tackle Box #1

{ tams # 87091 }

Print Recipe

Cardstock:
Night of Navy--5 1/2" x 8 1/2" scored at 4 1/4", 5" x 2" scored at 1/2", 2 1/2" and 3". Then cut down the middle to make two pieces that are 5" x 1" (pop up mechanism)]
Misty Moonlight--Inside Trays--4 1/4" x 5 1/2" (2), 2" x 5 1/2" (2), 3 1/2" x 4 7/8" (1), 1 1/2" x 4 7/8" (1), 1" x 2 1/2" scored at 1/2", 1 1/4", and 1 3/4". Then cut down the middle to make two pieces that are 1/2" x 2 1/2" (pop up mechanism)

Stamp with memento black all of the lures that you want to use in your tackle box. The stamps are two-step stamps so for the lures, I used Gorgeous Grape, Flirty Flamingo, Real Red, Crushed Curry, Azure Afternoon and Garden Green.

Die cut the inside large trays for the tackle box from Misty Moonlight. Cut TWO, these you will layer to give the box more dimension. Adhere these two layers together.

Die cut a portion of the tackle box dividers (2) as shown. Adhere these two layers onto of each other.

Adhere the bottom of the tacklebox to each piece. You will note that they are slightly smaller than the cut border for the box. Trim the pieces off shown.

Stamp the water look with Misty Moonlight or Night of Navy, depending on how dark you want it, into each of the dividers of the box.

Stamp the greeting with night up navy.

Die cut the lures and adhere into the tacklebox.

Biurnish the pop-up mechanism well. Adhere to the main card base about 3/4 of an inch to 1 inch from each edge.

Furnish that pop up mechanism for the upper part of the box and at here per diagram

Please glue only on the small half inch by 1 inch section of each of the pop-up mechanisms. Close the card and let the glue get hard. You will now have the box where you will adhere the lower tray of your tacklebox.

Adhere the lower tray to the night of needy pop up mechanisn.

Attach the upper mechanism the same way as the lower mechanism then attach your half tacklebox tray. .

Card front:
Adhere DSP if desired.

Using two of the larger pieces, and one of the smaller pieces from the inner tray to form the handle of the tacklebox. Stamp a greeting with night of navy on the smaller piece. Add dimensional.

Adhere the two larger strips to the front of the card base but them together then with dimensionals add the smaller sentiment to the top.

I used metallic enamel effects to make the rivets to hold the handle that on.