H
ere's a quick and easy card!
Card cuts:
DSP = Designer Series Paper
Card Base - Starry Sky = 5 1/2 x 8 1/2 scored at 4 1/4
Card stock - Basic White = 4 x 5 1/4; 3 1/2 x 5 1/2 (label and butterflies)
- Starry Sky = 1 1/4 x 2 3/4 (Butterfly Body)
DSP - Butterfly Kisses = 3 1/4 x 4; 2 x 4
Project Recipe
Stamping:
Stamp the following onto the 3 1/2 x 5 1/2 Basic White piece:
A. Using Starry Sky ink - Stamp the sentiment on the top of the 3 1/2 x 5 1/2 Basic White piece.
B. Stamp the dotted butterfly wing (leave enough space between this and the sentiment so that you can cut the sentiment out later.
C. Using Calypso Coral ink stamp the other butterfly wing
On the 4 x 5 1/4 Basic White piece stamp the following:
A. Stamp the sentiment in Starry Sky ink onto the center.
B. Then stamp the large dot butterfly wing in the bottom right hand corner making it look as if the butterfly is just flying onto the page.
C. Then stamp the other butterfly wing in Calypso Coral ink in the upper right hand corner making it look as if the butterfly is flying off the page.
D. Then using Starry Sky ink stamp the bodies onto the wings in the corner as shown.
Die Cutting:
Using the Build a Butterfly Dies cut the following:
A. Cut out the largest butterfly body from the 1 4/ x 2 3/4 Starry Sky piece.
B. Cut out the Stamped Wings.
C. Using the Deckled Rectangle Dies cut out Label around stamped sentiment.
Assemble:
A. Adhere 2 x 4 DSP to card front on the left side leaving a small edge on left, top and bottom side.
B. Adhere the 3 1/4 x 4 DSP to the card front flush to the first piece.
C. Adhere sentiment label about 1/4" from right side of DSP and centered top and bottom.
D. Turn butterfly wings face fown then place the butterfly wings together at the tops and secure with a piece of tape.
E. Turn face up and adhere the butterfly body to the wings.
F. Using Dimensionals adhere the butterfly to the card front as shown.
G. Apply Fun flowers as desired.
H. Adhere the 4 x 5 1/4 Basic White piece to the inside of the card.