C
ard Cuts: DSP = Designer Series Paper
Card Base: Highland Heather - 5 1/2 x 8 1/2 scored at 2 1/8 and 4 1/4
Card Stock: Basic White: 4 x 5 1/4, 2 1/2 x 2 1/2, 2 1/4 x 2 1/4, 1 x 3, 1 1/4 x 3 1/4 and 3 1/2 x 4 3/4
- Highland Heather: 2 3/4 x 2 3/4; 1 1/4 x 3 1/4 and 1 1/2 x 3 1/2
DSP - Hand Penned: (2) 2 x 5 3/8
Project Recipe
Stamping:
-On the 3 1/2 x 4 3/4 Basic White piece stamp the following:
-Highland Heather: Large Dahlia Image, two small flowers
- Mint Macaron: (4) Leaves, (1) Fern
-On the 1 1/4 x 3 1/4 stamp the "Happy Birthday" sentiment in Highland Heather
-On the 1 x 3 stamp the "smile" in Highland Heather
-On the 4 x 5 1/4 Basic White piece stamp two of the leaves in Mint Macaron ink (one in the upper left corner and one in the upper right corner)
-Then using Highland Heather ink stamp the small flowers one in the lower left corner and one in the lower right corner.
Using the Wink of Stella color in all the stamped images (Note: No need to wink of stella any of the sentiments)
Die cutting:
-Using the Dahlia Days Dies cut out the Dahlia's and leaves
-Using the Rectangle Stitched Dies cut out the sentiments and a stitched mattes from the Highland Heather strips
-Using the Layering Circle Dies cut out scalloped circles from the 2 1/2 x 2 1/2 and 2 1/4 x 2 1/4 Basic White squares and a scalloped circle from the Highland Heather square
Assemble:
-Adhere both of the DSP pieces to the card front one in each scored section.
-Adhere the smallest Basic White scalloped circle onto the top left section onto the DSP.
-Adhere two of the leaves and two of the small flowers onto this scalloped circle. (Note: pop up the top flower with a dimensional)
-Using Dimensionals adhere the other Basic White circle onto the Highland Heather scalloped circle.
-Then with Dimensionals adhere the large Dahlia onto the Basic White Scalloped Circle keeping the Dimensionals towards the center so that you can fit the leaves behind it.
-Now using Liquid Glue place two leaves and the fern behind the Dahlia.
****Be very careful and add some liquid glue to the back of the layered scalloped keeping care to only place the glue on the bottom half. Then adhere it to the bottom scored section keeping it as far to the right as possible.
-Adhere the sentiment label for the card front to the Highland Heather stitched matte, then using Dimensionals add them both to the card front on the bottom scored section in the lower left side.
-Adhere gems as desired.
Inside of card:
-Adhere the 4 x 5 1/4 Basic White piece that you stamped earlier onto the inside of the card.
-Using Dimensionals adhere the "Happy Birthday" sentiment onto the Stitched Highland Heather matte.
-Then place them both onto the inside of the card about 1" from the bottom edge of the Basic White piece. (Note: Before you glue it down you may want to make sure it's in the proper place for the easel to catch on it and stand up properly)