Tulip Fields Fun Fold Card

{ tams # 70722 }

Print Recipe

Adhere the Highland Heather Card Base to the Basic White Card Base. You will be attaching the 4 x 5 1/2 Highland Heather section to the front of the Basic White piece.

Adhere the 3 3/4 x 5 Flowering Tulip DSP to the Highland Heather card base front.

Adhere the 3 3/4 x 2 1/4 Flowering Tulips DSP to the front of the Highland Heather card base that is showing when it's folded in.

Using the Windmill Fields Dies cut out the following pieces:
- In Good Taste DSP piece (3 1/4 x 3 1/4) cut out the windmill blades.
- In Good Taste DSP piece (2 x 3)- Note I have already added the Adhesive sheet to the back so you do not have to do this step- cut out the detailed Windmill.
- Basic White (2x3) - cut out the solid Windmill.

Pull the backing off of the detailed windmill and apply it to the front of the Basic White solid Windmill.

Using the cork board and push pin, poke a hole in the top of the windmill and attach the blades with a brad. NOTE: do not tighten the brad down tight as you need the blades to turn.

Using liquid glue on the bottom half of the Windmill apply it to the front section of the card making sure that no glue pushes out to any section that is not touching the front of the card.

Using the Scallop Contours Dies and the 4 1/4 x 5 1/2 Highland Heather piece cut out a frame.
- Using Gorgeous Grape ink stamp the windmill in the bottom right hand corner and the sentiment onto the top of the frame.
- Adhere to the inside of the Basic White card base.

Using Gorgeous Grape ink stamp the sentiment onto the 3/4 x 2 3/4 Highland Heather piece keeping it centered.
-Then using the Rectangle Stitched dies cut out a label.
-Using Dimensionals adhere to the front card base just under the Windmill.